First layers K8400 - Software (Repetier & Cura) - Whadda forum

Forum. I have a problem printing the first two layers. With a hole within the model, the outline is only printed twice, while the edges are printed 3x for the outline of the entire model. With the next layers, all edges are printed 3x. Another question, the setting so that the nozzle does not go over the finished model so that no wires are pulled over the model. Greetings Auke

First Layer Calibration Pattern [from Prusa MK3/MK3S firmware] by

First layer calibration test : r/prusa3d

Calibrating the print settings for K8400 - Cura (OSX) - Vertex

Cura doesn't generate first layer raft for internal support if

Add Vertex K8200 on cura 3.6 - UltiMaker Cura - UltiMaker

WeldingWeb - Welding Community for pros and enthusiasts

Overhangs first layer – Assembly and first prints troubleshooting

Cura doesn't generate first layer raft for internal support if

Just tuned input shaping, the first layer is pretty fast, but

First Layer issues (still) - Repetier-Forum

Vertex K8400 and repetier host and CURA - Vertex - Printer

Printquality, backlash - Vertex - Issues while printing - Whadda

First layer issues v5.3.0 : r/Cura

First Layer Quality - Official Raise3D Community

Generating support inside infill - UltiMaker Cura - UltiMaker