Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Hello   I have a part that i want to machine with rotary toolpath but my sinumerik post will post TRAORI - but my control throws an error with i get to that command.   I wanted just to do it without it and just X Y Z A g codes - my origin is in the center of the rotary.   I have been searching but the post if found about disabling TRAORI dident work for me.    Any help is appriciated    

FUSION 360: Beginners & Intermediate Users' Guide: SUNDAY, SEYI O.: 9798359130219: : Books

Rotary Module with Fusion360: It works! (good enough) - Snapmaker 2.0 - Snapmaker: where creation happens

Preview: Autodesk Fusion 360 purchased assemblies and exclude from BOM options - OpenBOM

Fusion 360 Sinumerik 840D post - TRAORI Disable - Autodesk Community - Fusion 360

Fusion 360 CAM Turning - Setup and Tool Cutting Directions - Micrographics

Solved: How can I enable the workpiece in Siemens Turning post processor? - Autodesk Community - Fusion 360

How to set up a 4/5 axis machine configuration - Page 3 - Autodesk Community - HSM

Fusion 360 + Sinumerik 840d

Solved: How can I enable the workpiece in Siemens Turning post processor? - Autodesk Community - Fusion 360