Hotend pauses on print for a few seconds after finish printing

Any one know how to change settings/gcod so that the hotend does not pause on the top layer after it finish printing? This leaves a dimple where it paused. Thanks!

How to Avoid 3D Print Stringing: The Ultimate Guide

Time for a new hot end? Took hot end apart and found a ton of filament all over it. Cleaned and replaced nozzle only a few prints ago. Time for an all

After loading a filament, it prints fine for a few layers and stops extruding properly with clicking sound. – Assembly and first prints troubleshooting – Prusa3D Forum

firmware - CR-10 randomly pauses for a few seconds - 3D Printing Stack Exchange

Printing Small Parts - A Complete Guide

X1/X1-Carbon and AMS Firmware Release History

Hotend LOWERS after finishing prints : r/Ender3V3SE

Retraction: Just say No to oozing

Stops Extruding Mid Print

Advanced guide to printing PETG Filament

Quality Prints at High Speed: With PowerBoost 2.0 technology and Ultra Direct Extruder, AnkerMake M5C can achieve printing speeds of up to 500 mm/s

AnkerMake M5C 3D Printer, 500 mm/s High-Speed Printing, All-Metal Hotend, Supports 300℃ Printing, Control via Multi-Device, Intuitive, 7×7

Hot end just stops working - Snapmaker Original - Snapmaker: where creation happens

Genuine E3D V6 All-Metal Hot End (HotEnd) 24V Direct Drive Pre-assembl